What happens if bobbin tension is too loose?
A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.
How much tension should a bobbin have?
Proper bobbin tension is essential to good embroidery. If tension is too tight, unwanted bobbin thread may begin to show on top of your garment and you may begin to experience frequent thread breaks which wastes time and money. Bobbin tensions should be 18 to 22 grams (up to 25 grams when embroidering caps).
Will you adjust tension on bobbin thread?
As shown in the illustration, hold the bobbin case against a smooth vertical surface. If the thread with the weight attached is slowly pulled out, the thread tension is correct. Use the included standard screwdriver to turn the tension-adjusting screw and adjust the thread tension.
How do I know if my sewing machine has the right tension?
To test if the tension is correct, insert a bobbin in the bobbin case. Then hold it up by just the thread, the bobbin case shouldn’t move. Give a little jerk on the thread and if the bobbin case slides down slightly, then the tension if perfect. If it drops freely, then it’s too loose.
Stitches are loose on the top and/or bottom
- The upper threading could be threaded incorrectly. …
- Check the bobbin. …
- Change the needle.
- Check the combination of the needle and thread size as well as the fabric you are trying to sew on. …
- Using a scrap piece of material sew out your stitch and adjust the thread tension.
Why is the tension wrong on my sewing machine?
Needles, threads, and fabrics: Different thread sizes and types on top and in the bobbin can throw off basic tension settings. A needle that’s too large or small for the thread can also unbalance your stitches, because the size of the hole adds to or reduces the total top tension.
What tension should my brother sewing machine be on?
The normal tension setting is 4.0. The upper thread and the bobbin thread should cross near the center of the fabric. Only the upper thread should be visible from the right side of the fabric, and the bobbin thread should be visible from the wrong side of the fabric.
What tension should I use for cotton?
Cotton requires a moderate tension setting, usually between three and four.