Quick Answer: What is the best sealant for decoupage?

Can you put polyurethane over decoupage?

The time you spend decoupaging on each item will decrease as you gain experience. But much of the pleasure of decoupage is in the process, so what’s the hurry? — Applying three to eight coats of water-based or oil-based polyurethane. Each coat should dry thoroughly before you apply the next coat.

How do you finish decoupage?

To preserve the job, particularly if you expect the object to get wet, it’s wise to seal it using either varnish or polyurethane. Before you do so, gently buff the decoupaged surface with steel wool, then clean it with a damp cloth. Once it has dried, proceed to apply the sealer.

Do you need to seal over Mod Podge?

Do you need to seal Mod Podge? No, you do not need to seal Mod Podge. It is a glue, sealer, and finish all in one. The Mod Podge Hard Coat in particular has very tough properties that make it suitable for sealing furniture.

Which is better Polycrylic or polyurethane?

Oil-based polyurethane is very durable, making it the best choice for refinishing wooden floors or furniture that gets a lot of use, such as a table. … Polycrylic is a water-based product that is far less smelly and toxic than either type of polyurethane, making it easier to work with.

THIS IS FUN:  How do you know which is the right side of knitting?

How do you use Modge Podge as a sealer?

When you apply Mod Podge to a crafting design, use side-to-side strokes with a proper brush, and apply one layer of the sealer. You should allow the Mod Podge coating time to dry properly before applying up-and-down brush strokes with another even layer of the sealer.

Is Mod Podge clear acrylic sealer waterproof?

Protect all decoupage creations with a dust and fingerprint-resistant spray finish . Mod Podge Clear Acrylic Sealers can be used over water-based and oil-based paints, glazes, lacquers and varnishes . They dry clear, are waterproof, and non-yellowing .

Can I put Polycrylic over Mod Podge?

As far as applying a lacquer, Mod Podge is fine by itself, but if the project is going to experience a LOT of action, I’d brush Minwax Polycrylic on the top to seal. It might help make it feel slightly less rough too by building up the top layer. … Learn how to remove Mod Podge here.