How do you prepare wood for decoupage?

Do you have to sand before Mod Podge?

You do not need to apply the Podge thickly, as you will be adding multiple coats. Leave approximately an hour’s drying time between coats, and if you see any brush strokes you are unhappy with once each layer is dry, sand them out using super-fine sandpaper, and wipe down with a duster afterwards.

How do you prep for decoupage?

Decoupage: the basic technique

  1. Prepare surface. Once you have selected your item to decorate, make sure the surface of it is clean and dust free as the varnish magnifies any imperfections.
  2. Cut out pictures. Select your pictures and cut them out. …
  3. Arrange the pictures. …
  4. Glue the pictures in place. …
  5. Varnish the pictures.

How do you seal wood decoupage?

The short answer is, use Varnish to seal your Decoupage Project to make it waterproof. Varnish is a Sealer for wood but it can be applied to a lot of different materials. Varnish drys transparent and glossy.

How do you decoupage pictures on wood?

Regular Decoupaging

  1. Paint the surface of a block of unfinished wood with a thick coat of Mod Podge using a sponge brush.
  2. Place the photo right-side up on the wood. …
  3. Burnish the photo to remove any air bubbles and wrinkles. …
  4. Cover with two more layers of Mod Podge, allowing each layer to dry before painting on the next.
THIS IS FUN:  Question: What kind of paint do you use for wood carving?

Do you need to water down PVA glue for decoupage?

Once you have a pile of torn paper, put to one side then dilute the PVA glue with a little water and, using a small paintbrush, paste PVA glue onto the item you’re decoupaging.