You asked: How do you end embroidery?

How do you seal embroidery?

Place your embroidery face down on your ironing board. Center your Heat N Bond, paper side up, on the back of your work. Use a pre-heated iron for 1-2 seconds over your work. Use the pointy end of your iron to help seal any irregular edges around the entirety of your embroidery.

Do you leave embroidery in the hoop?

If the hoop is large enough to encompass the entire design, you can get away with leaving the fabric in the hoop, but it’s a good idea to loosen the tension a bit when you’re done stitching. If your hoop is smaller than your design, you definitely want to take the fabric out when you’re done stitching for the day.

THIS IS FUN:  Frequent question: Can you exchange on stitch fix?